-------------------------------------------------------------------------------- Configuration script for Repeater Modules from Jonathan Naylor, G4KLX Copyright (C) 2012 Hans-J. Barthen, DL5DI (dl5di@gmx.de) -------------------------------------------------------------------------------- The text based "repeater_conf" configuration program allows to configure the G4KLX repeater modules. The recommended way for the initial installation of a repeater with gateway is to configure the gateway first using the configuration tool "ircddbgw_conf". This program will automatically involve "repeater_conf" during the configuration of a software repeater module. This will make sure that the settings of gateway and repeater module match to each other. PLEASE NOTE: repeater_conf reads the gateway configuration but the ircddb_conf does not care about the repeater configuration! On a standalone repeater without any gateway you may start "repeater_conf" direct. The program takes 0 to 2 parameters. repeater_conf with 1-4 this value has to meet the module index of ircDDBGatway! 1-4 1 soundcardrepeater 2 dvrptrrepeater 3 gmskrepeater 4 dvapnode These commandline parameters allow to start the program from other software. When called without commandline parameters the program will request the values. Setting up a soundcardrepeater requires ALSA to be installed. Please note that the soundcard part is not really tested! The soundmodem configuration is different from other modem setups, it specifies all devices by full text names, not by clearly defined devicenames. Example: [HDA Intel ALC662 rev1 Analog (hw:0,1)] The ALSA tools allow to read that names and offer it for selection. If you use other types of modem devices or can use "default" or can once set the value by the repeater in GUI-mode you won't need ALSA. Files: /etc/soundcardrepeater_* configfile for soundcardrepeater module * (1-4) /etc/dvrptrrepeater_* configfile for dvrptrrepeater module * (1-4) /etc/gmskrepeater_* configfile for gmskrepeater module * (1-4) /etc/dvapnode_* configfile for dvapnode module * (1-4) /etc/default/repeater_conf default values for all settings /etc/init.d/repeater_* startscripts for repeater module * (1-4) /usr/share/repeater_conf/*.hlp helpfiles in different languages /usr/share/repeater_conf/*.mnu menufiles in different languages /etc/sysconfig/repeater_* binarypath and commandline options for repeater module * (1-4) This last file need to be edited before the configuration if you want to change the logpath or switch logging on/off. PLEASE DO NOT EDIT and other files manually unless you know exactly what you are doing! Manual entries may cause issues and double entries. repeater_conf will create the basic configfile for the repeater module and also the options file in /etc/sysconfig. Special menu options allow to activate the automatic startup script or manually start the repeater. Please address ideas, bug reports and experiences in the Yahoo Group "PCRepeaterController". august 25th 2012 Hans, DL5DI